Faceplate for Screws
Stable, well-adherent covering caps hide counter-sunk screws
Online since: 07/05/2008,
Number of visits: 295579
0
With a knife, carefully trim 2 mm off the end of the shaft.
Push a suitable disc magnet
or ring magnet
into the hollow shaft.
For the caps in the picture a ring magnet type R-06-02-02-G
was used.
The entire content of this site is protected by copyright.
Copying the content or using it elsewhere is not permitted without explicit approval.
Copying the content or using it elsewhere is not permitted without explicit approval.